Gearbox capacity - Splitter: gear lube 80-90W EP / Center & wings: gear lube 80-90W EP
Gearbox horsepower Splitter: 160 hp (119 kW) / Center & wings: 100 hp (75 kW) | 6 Spline
Input: Category 4 with constant velocity u-joint | Intermediate & wing: Category 3 with slip-clutch
20.5" x 6.75" x 10" (52.1 cm x 17.1 cm x 25.4 cm) used aircraft tires or 21" (53.3 cm) laminated wheels | Number of: 4 - Wheels: 2 on transport axle and one on each wing axle
Blade tip At 540 rpm - Center Blades = 16,500 FPM (83.8 mps) / Wing Blades = 16,000 FPM (81.3 mps)
LP Performance hitch and swivel hitch
Signal: LED / 7 Pin connector: SAE J560 pin configuration
Gearbox shafts Input shaft: 1 3/8" (3.5 cm) 6 Spline / Output shaft: 1 1/2" (3.8 cm) | Cutting capacity: 1 1/2" (3.8 cm) | Lift hydraulics: 2 1/2" bore x 8" stroke hydraulic cylinder, hoses, fittings and stroke control spacers | Wing folding hydraulics: 2" bore x 8" stroke hydraulic cylinders, hoses, and fittings | Wing flex while operating: Max. 20° down, can float up as needed as long as the wheel(s) are still on the ground. | Blades - 6 (2 per deck): 1/2" x 3" (1.3 cm x 7.6 cm) Heat treated free swinging alloy Steel with up lift | Blade overlap: 6" (15.2 cm) | Stump jumper / blade holder: 10 Gauge (3.4 mm) round dish shaped pan, reinforced with 1" x 3 1/2" (2.5 cm x 8.9 cm) blade bar
12'-0" (3.66 m)
cutter: 12'-7" (3.84 m)
Minimum: 7'-11" (2.41 m) With front cutting blade 1 1/2" (3.8 cm) off the ground.
Wing transport protection: Wing transport locks | Skid shoes - Wing deck: 1 replaceable per wing / Center deck: 2 replaceable shoes | Blade rotation Left wing: Counterclockwise / Center deck: Counterclockwise / Right wing: Clockwise | Blade bolt: Keyed with hardened flat washer and locknut | Front & rear guards: Single chain | Transport axle: Spring-cushioned lift cylinder
Hitch: 793 lbs (359.7 kg) | Machine: 2,540 lbs (1152.1 kg)
10 Gauge (3.4 mm) deck
Side skirt: 3/16" (5 mm) Plate
Cast iron five-bolt hubs with tapered roller bearings and 1 3/4" (4.4 cm) shafts.
